Polyurethane Floor Finish Fill Low Spots

Easy application and cleanup.

Polyurethane floor finish fill low spots. Say you ve got a 1 000 foot floor and two gallons of finish. You re on your last stretch and realize you re running out of finish and may not have enough to finish the job so you start putting more pressure on your applicator and begin squeegeeing out finish to ensure you get a coat on the whole floor. I had my hardwood sanded and refinished and high gloss put on. Polyurethane can also be harnessed as a foam and a liquid and it makes up most wood floor finishes.

Both water based and oil based products give off strong fumes as they dry although oil based is decidedly worse so proper ventilation is a must. Low odor and low vocs. So i had it buffed and recoated with the polyurethane and still the spots are popping up everywhere where the polyurethane did not stick. On the plus side it is an extremely hard.

That s a lot of time for dust to settle or bugs to land on the surface marring the final product. This would prevent burning the finish then you would have a sealed surface to apply the remaining coats to. Cloudy finishes appear for several reasons including using an old product or one that s been stored in a very cold or hot environment. If you want to clean a stain that appears on a polyurethane coated surface without ruining the finish you must use caution.

Very smooth and shiny finish. Proper application also requires stirring the polyurethane coating immediately before placing it on the surface which should be clean and oil free. As a clear finish for woodwork polyurethane has advantages over lacquer and alkyd varnish but it also has disadvantages. Polyurethane takes hours not minutes to dry.

Keep consistent mil thickness. Finish repelled in spots. It would have been easier to finish the initial application let the finish dry for a couple of days then wet sand it down to a dull sheen with 400 grit wet dry paper using water with dishwashing liquid in it as a lubricant. It had little round spots all over it that the polyurethane did not cover.

To combat the textured surface cleaning challenges too many customers or janitorial services choose to apply a finish to fix these problems thinking that the cured finish will fill low spots in the wear layer and negate the textural challenge to maintaining the product. I put a final coat of polyurethane on my wood floors and noticed that i missed a spot where my roller didn t overlap in application after the floor completely dried i tried touching it up by rolling on some poly but the finish is matte and somewhat cloudy from what i first applied.